A1 HYDROGEL

OVERVIEW
SunP Gel A1 is a biodegradable bio-ink developed for 3D bioprinting. It has good biocompatibility and fast degradation making it suitable for most human and animal-derived cells. The cell survival rate after printing is higher than 85%, and the product comes in both gel & powder form
ADVANTAGES
- Good biocompatibility, degradable
- Good molding effect and long structure retention time (more than 30 days)
- Easy to operate, mix with cell suspension to print
- Wide range of applications, suitable for most human and animal cells

Interested? We would love to talk with you!
TECHNICAL SPECIFICATIONS
- A1 HYDROGEL
- A1 FREEZE-DRIED POWDER
A1 HYDROGEL | A1 FREEZE-DRIED POWDER | |
Gel | Powder | |
Form | Colorless or light yellow gelatinous | White lyophilized powder |
Packaging | One 3ml hydrogel in each box | Two bottles of 500ml lyophilized powder in each box |
Stocking Time | 3 days | 7-10 days |
Solubility | Place in a 37-40 ° C oven for 20 min, the product is in a fluid form, can be mixed with PBS, saline, complete medium, etc. | Add PBS, saline, complete medium and other solvents in proportion, place in a 40 ° C oven or water bath, completely dissolved in 30 minutes |
Sterilization | Sterile | Non-sterile |
pH Value | 7.0- 7.5 | 7.0-7.5 |
Shelf life | 3 months | 6 months |
Storage Method | 4°C | 4°C | Buy Now | Buy Now |
RHEOLOGICAL PROPERTIES
A1 GEL

A1 POWDER

The gel temperature was measured by Anton Paar MCR302 rotational rheometer. Measurement parameters: deformation range 0.1%, test frequency 1 Hz, cone plate diameter 25 mm, cone plate slope 2 °, cone plate The distance between the tip of the cone and the bottom plate is 99 μm. Gel point test results: 24.0-26.0 °C
CELL VIABILITY STUDIES
A1 GEL

A1 POWDER

Figure 3: HUVEC-24h live staining
The cell viability of Hela, A549, NIH-3T3 and HUVEC cells was detected by Calcein AM-PI kit for 24 hours. Under confocal observation, the living cells showed green fluorescence and the dead cells showed red fluorescence (Figure 3).
CELL VIABILITY TEST RESULTS
Cell type | Hela | A549 | NIH-3T3 | HUVEC |
Survival rate | ≥90% | ≥85% | ≥90% | ≥90% |
Figure 4: HUVEC-24h live staining
The cell viability of Hela, A549, NIH-3T3 and HUVEC cells was detected by Calcein AM-PI kit for 24 hours. Under the confocal observation, the living cells showed green fluorescence and the dead cells were red. Fluorescence (Figure 4).
CELL VIABILITY TEST RESULTS
Cell type | Hela | A549 | NIH-3T3 | HUVEC |
Survival rate | ≥90% | ≥90% | ≥85% | ≥90% |
PRINTING APPLICATION EXAMPLE
Bio-ink was prepared by mixing NIH-3T3 cell suspension with SunP Gel A1, and the three-dimensional structure was printed. The culture medium was cultured for 7 days, and the cells were proliferated from single cells into cell clusters. The specific morphology is shown in Figure 5.

Figure 5: NIH-3T3 cell mass (7day)
Interested? We would love to talk with you!